Activity Stream

I figured i wanted to fix this "corpse" now. I removed all excess solder in the input-area and measured the resistance between GND and each of the...

It is nice to have adjustable high and lowpass, cutting lows will clean up the 'satellite' speakers. The point of the filter I proposed is that it...

understood, but then i still have to cut low freqs from the main speakers- that i first thought im not gonna do, cos i like how they sound only if...

The subwoofer amp has a low-pass filter for the subwoofer itself. But that amp has no high-pass filter for the main speakers. That means that the...

this one seems easy enough, but whats the whole point of having subwoofer amp ( http://www.audes.ee/?id=1267&tpl=1003 ) if i still need this low...

Maybe this is simpler for you:...

You need a power supply with it and then it is simple, apply stereo line signal audio and then there is a mono output. I don't have a picture, maybe...

yup, i have already done that. moving them closer to walls, but then again mids are not so great as before :) V-bro can you send me some picture...

that's incredibly reasonably priced. dfx, if you are happy with the tone of the bass from your main speakers then it may be worth while to play...

This would work:...

well thats exactly what i wanted to do, add a LITTLE bit more bass that the mains speakers are producing. for sure i dont want to cut off bass freqs...

Do you understand that you're not really doing any crossing over? merely adding more bass to the bass that the main speakers are producing since they...

i dont understand what do you mean ? you can adjust crossover freqs and bass level from the subwoofers amplifier, right near where you connect...

does that even work?? I mean more than adding a dull thud to the music. I can see the appeal to simplicity, but holy crap that is a pretty nasty...

Yes, that's the correct way to go.

Do you have any specific tactical places? Or just about anywhere? Around the big electrolytic caps, the rectifier and stuff like that?

I think that might be it... The chip is NOT insulated from the box - The AI says: "The heat slug of the TAA4100A chip is connected to ground and...

Did you also use mica or any other form of insulation? The chip MUST NOT make electric contact to the case... And yes you can measure whether...

By the way: The heatsink i use is a casing recommended by Saturnus: Hammond 1590n1. It is obviously tightly connected to the chip and I also used...

I use 2,5mm^2 wire, the terminals do not seem to be able to support thicker wires than that. Are there any specific things that I might be able to...

Beep tones come from the modulator, for instance when there is lack of current. In an extreme case it could be due to poor heatsinking. If that is...

I'm not sure - the problem solved itself - the noise is gone. However a new problem popped up; After having the AMP playing for about one hour at...

With input cabling attached and without as well?

I received the new tripath-chip yesterday, and removed the old chip. Surprisingly i was able to clear all the holes relatively easy, even though it...

Congrats on those amps! And good that you did find the error soon enough. That ticking sound means that there's an error condition and the Tripath...

Finish building the second amp6. Thought I had done a better job of soldering that the first one, checked each solder joint as I went, connected...

That is correct. :-) Good luck with your build!