Bridging AMP10

[abelma]

I dont have the AMP10 yet, and i dont have also the assembly or user manual. That would be good to make the final move for this model. Anyone?
Anyway, my question (May be in the manual) it's simple, for bridge mode, what are the procedures and connections? I can see the output diagram in the web site, and where to switch for bridged output.
I doubt about the input. It would be the same connecting the input in the right OR left channel?
Thank's

[Greg]

You usually ground the unused input via resistor, you need to know witch one though [?]

Greg

[thomaseliot]

Hi,

No, it wouldn't be the same. For bridged AMP10 you have to connect only Channel 1 input. Channel 2 input is unconnected, because through the bridging jumper it becomes the inverted version of Channel 1.

[abelma]

Thank's !...I wonder if i can put a switch to change in bridged and stereo...i think so

[thomaseliot]

Yes, two pins are provided for that.

[abelma]

OK. ..i am assembling now the AMP10, and i can see that option. I leave the input caps installed to change them very easy for a better ones. In your experience, what input caps works better for You thomaseliot . Thank's !