r21 and r22 label missing from TOP schematic

[wadoka]

Hi,

The label for R21 and R22, each a pair of 10R 2w resistors in series are missing from the TOP view schematic 1.02, although their placement is marked by a couple of circles with a line between them.
They are between c24 and c35 on one side and c25 and c36 on the other.
Its not so hard to work out what the missing label should be, but I thought I would point it out anyway.

Matt.

[V-bro]

Yes, there will be an illustrated assembly instructions doc too, so it'll be no big deal...

Did you figure out the TO220 spacer setup? It's very important to have these under the seatslugs when soldering to keep the right distances! The fets only need the larger washers, but the transistors and rectifier diodes need both the small and the larger washers to get the same distance. Otherwise there will be a lot of mechanical tension on these devices (and PCB) because they don't line up to the flat surface when bolted down...

If you like I can mail you some pics of this tomorrow?

------X-max. can be several meters on any driver, too bad it can be done only once...------

[Jan]

Thanks for pointing this out. I have updated the top side component placement picture with R21 and R22, in the AMP15 Schematics and BOM file on the downloads page.

[wadoka]

V-bro Yes please :) I was wondering about how to do that part.

Jan Glad to be of some small help.

[V-bro]

Here you are Wadoka:
http://41hz.com/Forums/topic.asp?TOPIC_ID=2330

------X-max. can be several meters on any driver, too bad it can be done only once...------