amp10 basic questions

[wadoka]

Hi,
Can someone tell me what what j36 j39 j38 and j35 are? Also where are the analogue signal inputs and what do I do with the various jumper settings, I like the amp powered on all the time but with a mute switch on the front panel,

Thanks!

[Anton]

If you check the long BOM document you should find most connections there.

>j36 j39 j38 and j35?
Cant seem to find these on the board. Do you mean J3 connector? Those are external LEDs. J2 for mute and input signal is J1, where pin 1 and 4 is input and 2,3 is ground.

Never build a amp10 so not sure what jumper settings needs to be done. I only see J10 which seperates +5v section from the tripath chip so you can measure that you have 5v before closing it. I guess you can check the amp10 non-basic instructions for hints on building amp10 basic since they should be pretty similar.

Good luck on the build!

[wadoka]

Ah yes, I meant J6 J9 J3 and J5...sorry.