Bridging Questions

[snoopy]

My two amps are built, tested, and mounted on a bespoke board. The sound quality from one is just amazing through the B&O Pentas. Truely awesome.

So then next stage is bridging the buggers and getting that 150w per channel. I've done the resistor mod but need to know.

1. Which input do I use, the one closest to the edge of the board or the one below it?

2. With the tripath chipset at 12oclock, does the speaker positive go into the left side positive or the right side positive?

Pictures of this beast coming soon!

[snoopy]

All sorted, it's the input at top corner and left speaker output is the positive.

[ris]

quote:Originally posted by snoopy

All sorted, it's the input at top corner and left speaker output is the positive.

Hi, I have another question.
If I choose the top corner for input then I don't need the other chanel input capacitor?

It's important for me, because I plan to build a stereo amplifier with two bridged AMP10 with replaced input capacitors (C35, C36). These new input capacitors are expensive, so it's an important point that I need four input capacitor for the two bridged AMP10, or just two.
If two needed, C35 or C36 place is to leave empty?

ps: Sorry for my english.