hi,
after successfully building an amp6 i thought it is time to move on and make an amp 3.
turning it on the first time and messuring the current it draws i notice it draws 0.3 A and the ship gets quite hot in a few seconds without any source connected. also there is an voltage (9V) on one input channel, and less on the other

i had some problems soldering the ship. it is not perfectly alligned, but it still looks like they all have the right contact. i also had solder between some of the legs. so the ship might have become a bit hot whilw removing it, but i am quite positive that at least ther is no shortcut between any legs.
is the ship damaged? any hints to find out whats wrong?

thanks
felix