I have recently completed my AMP-5 kit and now I have finished the speakers for the amplifier.
When I just had built it I had some problems with the DC output on the speakerterminals. But I fixed it then, but now I have the same problems and the VDC won't go below ~12,7. It's only one channel that has that problem the other one is at ~0,001mVDC.
I have followed and measured on almost every solderpoint and the voltage is completely off the charts if I compare to the other channel. By the potentiometers the working channel has ~0,001VDC over it and on the faulty one it's ~5VDC.
Could anyone help me with trying to solve this problem or should I give up an order a new kit?
The reason to why I said that I would order a new kit is that some solderpoints are wrecked and have separated from the PCB.